Dodge Durango Blower Motor Not Working

Its a fuse f13 my ac woldnt blow air in the front just the back changed the fuse now its good. Web result but today i got the durango back from the shop where they replaced the rear end and for some reason now the blower motor for the front is acting up. Now front blower blows at the correct speed on high or low. Gururhkcf answered 4 years ago. Web result 1 answer.

Sunday, december 19th, 2010 at 7:36 pm. What i think happened was that the blower motor overheated and the relay under the dash allowed too much current to the fusebox under the hood + it ended up melting the tipm. When it fails to work next time, find it under the passenger side dash area, and give it a good thump. Sometimes when a thermostat goes bad, it stays stuck open. Web result it turned out that i needed to replace the tipm as well.

Have checked fuses #13 and k in left fender box? Then remove screws with a 1/4 inch ratchet and a 7mm or 8mm. Disconnect the largest clip underneath tipm. Check the owners manual of your durango or the fuse box cover to find the exact location of the fuse for the blower motor. I simply replaced the blower motor with a pick a part one two weeks ago and that solved the problem.

Sounds like a blower motor resistor.it is located on thr passenger side, about where the passengers toes would be. Then unhook the tipm retaining clips flip it over. Gururhkcf answered 4 years ago. Yes, my 2000 dgc 3.3 had intermittant front blower low speeds even tho it was on high. Then remove screws with a 1/4 inch ratchet and a 7mm or 8mm.

61k views 7 months ago. Yup, there's a jumper in the resistor assembly that can fail. If i have it on the lower settings it works, but if i put it on high it doesnt work. Web result 107k views 7 years ago.

Yes, My 2000 Dgc 3.3 Had Intermittant Front Blower Low Speeds Even Tho It Was On High.

Now front blower blows at the correct speed on high or low. 2 posts · joined 2021. Sprinkles08 and 87 other dodge. You must have the auto climate control, because the resistor packs for the manual ones are usually $50 or less.

Sometimes When A Thermostat Goes Bad, It Stays Stuck Open.

Web result the front fan on my '01 suddenly stopped working (the back one works fine.) my first thought was the blower resistor, but it doesn't work even on the high setting. Web result the module could be bad, a harness could be loose, or the blower motor could be on it's way out. You should be able to apply 12 volts to the motor to see if it runs. What i think happened was that the blower motor overheated and the relay under the dash allowed too much current to the fusebox under the hood + it ended up melting the tipm.

If Yes Need To Check For Voltage At Hvac Select Switch.

Have checked fuses #13 and k in left fender box? This is what caused intermittent functionality of the hvac up front. Do you have a volmeter? I would not expect the resistor module to be more than the blower motor.

Disconnect The Largest Clip Underneath Tipm.

The rear ac and blower works just fine and blows very cold air. Web result ask an expert. Pop open the fuse control panel in the cabin (not the one that's in the engine compartment). Low coolant or air in the cooling system.

Did you find out what it was ? Check the battery and fuses first! When there’s no air flowing through the vehicle’s cabin, a bad blower motor usually causes this scenario. Do you have a volmeter? It is held there by two 8mm screws.but slide the red tab toward the driver, press the black tab and remove wiring harness.